Enerpac PL-Series Manual do Utilizador descarregar pdf (Página 5)

INSTALLATION

Hydraulic Connections

To make port connections, install fittings rated for 5000 psi (350 bar).

Cylinder Ports

Cylinder Capacity 350 bar (5000 psi) Fitting

2,2 kN (500 lbs.)

BSPP

5,6 kN (1250 lbs.)

BSPP

9 kN (2000 lbs.)

BSPP

35 kN (7900 lbs.)

BSPP

DO NOT use thread sealant. Sealing is accomplished by using an o-ring on the fitting

boss. Lubricate the o-ring prior to assembly.

NOTE: When designing your hydraulic circuit, consider the factors listed in

PRELIMINARY INFORMATION on page 2. For more information about plumbing

hydraulic circuits, see your Enerpac Production Automation Catalog.

Port Identification

OPERATION

A CAUTION

—To ensure maximum cylinder performance and safety; be sure all hydraulic

connections, hoses, and fittings are properly sealed and fully tightened.

—Be sure all items are rated to withstand system pressures. Under-rated

components will not withstand higher pressure. Using under-rated

components will lead to equipment damage and possible personal injury.

Manifold Ports

Side View

Threaded

Body Style

Upper Flange

Body Style

Lower Flange

Body Style

A: Clamp Port 

B: Vent Port (Single-acting Models)

Unclamp Port (Double-acting Models)



NOTE: Do not remove vent plug except

to attach tubing (See vent plug section).

Manifold Ports

Side View

Bottom View

KEY

1 2 3 4 5 6 7 8 9 10 ... 31 32

Comentários a estes Manuais

Sem comentários

Enerpac PL-Series Manual do Utilizador Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas Enerpac PL-Series